Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

• All bolts to have Loctite 243 adhesive applied unless otherwise stated All Threaded Pneumatic connections to have Loctite 570 applied All bolts to be pen marked once adhesive applied and correct tension added  +
• D0004015 Front Slider D0004016 Rear Slid … D0004015 Front Slider D0004016 Rear Slider 1 Add M6 x 6 grubscrews to indicated holes, 4 off in total. Use Loctite 572 to seal grubscrews to blocks . Ensure grubscrews sit flush with face of block when fitted. Tap hole deeper with M6 tap to allow grubscrew to sit further in if not possible to achieve flush fitment .
  
  ...Always use an airline to remove internal swarf from blocks is tapping is required
  2 Fit 4 off B0000033 Linear Bearing as shown. Ensure yellow face of bearing is fitted on the indicated faces. Ensure when fitted that no ball chamber is visible on bearings 3 Fit 4 off M6 straight grease nipples to indicated points (2 per slider) Use loctite 572 to seal
  ff M6 straight grease nipples to indicated points (2 per slider) Use loctite 572 to seal <br/>  +
• Degrease blocks before fitting bearings Fit 2 of B0000033 Linear Bearing to 2 off D0004420 Extension Linear Block Ensure yellow seals are facing the shown direction Apply liberal grease to these bearings  +
• Insert H0004630 Shaft 20mm: 345 Ejector Cr … Insert H0004630 Shaft 20mm: 345 Ejector Cross x 1 into D0004329 Rod End Plate (5304) as shown Dimple in shaft is offset, when correctly fitted, shaft is equally protruding either end of block Secure with M8 x 20 kcp grubscrew, ensuring dimple is entered by the grubscrewnsuring dimple is entered by the grubscrew  +