Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

• Depending on the cable being used, will de … Depending on the cable being used, will determine which of the grommets will need to fitted. The 'white' grommet is the most common and is also the grommet used in the example pictures. Be aware that if a smaller cable is being used (ie; a reed switch) the smaller of the additional grommets should be used. All grommets are fitted in the same manner and orientation.fitted in the same manner and orientation.  +
• Inside the packet of the plug will be 5 co … Inside the packet of the plug will be 5 components: 1- Metal outer shell 2- Numbered insert 3- m8 IDC connector 4- Individual 'white' grommet 5- Additional 3 grommets
  ...The 'white' grommet and numbered insert may be stuck in the metal shell. Please check!
  Make sure you check that you have all of these parts before disposing of the packaging.gt;Make sure you check that you have all of these parts before disposing of the packaging.  +
• Make sure the tapared end of the shell goes over the cable first.  +
• Once you have your cable run to its final location and cut to length, you will need to strip 20mm of the insulation back to expose the internal cores (The cable used in the example picture is a 2 core cable with 1 brown core and 1 blue core).  +
• Place the wires through the insert. The in … Place the wires through the insert. The insert has coloured numbers around the outside that correspond to a hole. The brown wire in this example goes into the hole next to the brown number 1. The blue wire goes into the hole next to the blue number 3. Nothing goes in the hole next to the black number 4. The insert needs to be pushed into the rubber grommet, ensuring the tabs on the insert and grommet line up. Once the insert has been pushed all the way into the grommet, the remaining wire that is pertruding from the end, needs to be cut flush. Different cables and different components will change which colour cores core into each numbered hole. Always check the electrical drawings before this step. There is a file attached to this Dokit which has further information. this Dokit which has further information.  +
• The insert has a rebated section which is … The insert has a rebated section which is designed to only allow the IDC connector to be pushed on in one orientation. To fit the IDC connector, line up the details and push the IDC connector firmly into the insert. The IDC connector has contacts on the inside which will cut into the cores in the insert. This is how the electrical connection is made between the cores and the pins in the plug. The bottom of the IDC connector has a thread to accept the metal shell. The metal shell should be hand tightened on the insert for as far as possible. Once it is finger tight, to sets of pliers will be needed to tighten the remained of the way.
  
  ...When using pliers to tighten, only turn the metal shell, keep the IDC head static!
  You will see a green O ring on the IDC connector, this is a good guide to use to know when the shell is tight enough to the connector. When you are unable to see the green O ring is when the plug is correctly tight. the connector. When you are unable to see the green O ring is when the plug is correctly tight.  +