Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

• <div class="icon-instructions caution-i …
  ...Do not attempt this if the square end datum positions are not consistent
  Run the test at the same position on all 3 profiles
  nsistent</div> </div>Run the test at the same position on all 3 profiles <br/>  +
• All gripper positions should be greater than 20 and less than 55  +
• Cut 3 lengths of outerframe around 1000mm … Cut 3 lengths of outerframe around 1000mm long
  ...Make sure the gripper end of the profile has a clean edge - ie no swarf and profile tape is not "flapping" over the end
  
  ie no swarf and profile tape is not "flapping" over the end</div> </div><br/>  +
• If the position is varying, this highlight … If the position is varying, this highlights a gripping / measuring problem Check * Laser focus and alignment * G axis Datum position * Y axis datum position * Speed of infeed pull is steady and slow * Gripper slipping (blunt)
  ...The position needs to be identical before you can proceed to next step
  
  on needs to be identical before you can proceed to next step</div> </div><br/>  +
• Run 3 tests on the same piece spaced apart … Run 3 tests on the same piece spaced apart by 20mm. Make sure the machine is reinitialised and redatums between each run. This allows you to see if the position of the holes drifts along the bar Aim to place the holes at least 400mm in from the bar end See [[WinMulti - Datum Test]] for full instructions End goal is to produce repeatable datum holes at the correct position from the end of the bar
  ...The position needs to be consistent and repeatable before you can proceed to next step
  
  
  ...If the datum position is not consistent, check laser beam cleanliness and laser focus
  See [[Training Laser on Ecoline]][[Training Laser on Ecoline]]  +
• Run the tests again with arrowhead end on the test pieces. If the position is different to the square-end, the position can be adjusted with the parameter ecoArrowAdjust  +
• The position can be adjusted with the para … The position can be adjusted with the parameter ecoMitreAdjust After adjustment, run the tests again
  ...Only make an adjustment if you have consistent, repeatable results
  
  ake an adjustment if you have consistent, repeatable results</div> </div><br/>  +
• Usually - A - Slim Outer frame B - Larg … Usually - A - Slim Outer frame B - Large Outer Frame C - Door Profile Cut \ / pieces around 1000mm
  ...Make sure the gripper end of the profile has a clean edge - ie no swarf and profile tape is not "flapping" over the end
  
  ie no swarf and profile tape is not "flapping" over the end</div> </div><br/>  +