Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

• Ensure that the brush strip is installed i … Ensure that the brush strip is installed in the segment. Offer the segment into position, ensuring it sits on the mating faces. Ensure the large diameter hole is sitting over the top of one of the grease nipples. When in position, mark through the counterbored hole to mark the drill position on the back plate with a marker pen. Remove the segment. Drill and tap M5 at the marked position Clean away any swarf, with the airline. Add 3M tape to the inner radius face of the back plate. Ensuring the brush strip is in position, install the segment back into the same position and then secure using the M5 bolt and washer. Install the cap to cover the grease nipple access hole.ap to cover the grease nipple access hole.  +
• Repeat the process for the remaining segme … Repeat the process for the remaining segments. Note that the segments have tapered ends to allow each new segment to slot underneath the already fitted segments. With each new segment being installed, it is critical to ensure that it butts up against the previous segment closely. This is so that when the last segment is installed, it has the required room to fit.nstalled, it has the required room to fit.  +
• The last segment should fit exactly the sa … The last segment should fit exactly the same as the others. The tapered ends have been designed to allow it to fit under the fitted segments on the ring, and then drop down into its final correct position. If, however, the last segment does not fit, provision has been made on one end of each segment to be “hollowed out” when printing, showing just the walls. This allows it to be filed or sanded back, to allow proper fitment.d or sanded back, to allow proper fitment.  +
• Using an air line and brush, clean away an … Using an air line and brush, clean away any and all swarf and other debris from the slewing ring. Next, using the rags and the FE10 solvent, wipe down the mating faces on the inside radius of the rear plate Once clean, scuff the surface with the scotchbrite pad. Wipe down the surface again with the solvent and rag.he surface again with the solvent and rag.  +