Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

• * Thorough blow down of the Machining Centre Module * Visually check tooling for damage or swarf buildup * Check the V notch blades are not buckled * Check M/C rollers for tape build up * Empty M/C waste boxes if required   +
• * Thorough blow down of the infeed module * Blow down of the gripper carriage * Wipe the offcut measurement sensors * Remove swarf from grip finger teeth   +
• * Thorough blow down of the saw module * … * Thorough blow down of the saw module * Remove any loose waste pieces in the saw * Check the the rear rollers and saw beds for profile tape buildup * Check saw blade pulley belts (tension/replaced as required) * Empty saw waste box if required * Empty extraction waste pieces from cyclone / hopper box tion waste pieces from cyclone / hopper box   +
• * Thorough blow down of the saw outfeed * Thorough shake of the extraction top cloth bags * Change lower extraction bags as required   +
• To check the machine is ready for producti … To check the machine is ready for production, a couple of simple tests can be run # Datum Test # Pos Test
  ...Do not attempt to make any adjustments to the machine on the basis of one test. If there is an error, run the test again twice more. !! Adjustments are only effective if the error is repeatable !!
  
  
  ...The machine tolerance is +/0.5mm, so there is no need to adjust if an inaccuracy is less than this tolerance (1mm back to back)
  
  olerance is +/0.5mm, so there is no need to adjust if an inaccuracy is less than this tolerance (1mm back to back)</div> </div><br/>  +