Toutes les discussions

The photo should really show the important bit about the screwdriver - the pozi head

All Zx5 machines can do this with the any version of software

Z010 - (Oct 2023) output no.394 in conflict - now sorted - see GG note for 425 to 432

Z082 is a ZX5E - No Beam on GX axis - How many links will it need

The sensor gap should also be checked after installation. The maximum Gap to operate is upto 4mm. ideally the sensor should be setup to read closer than this - about 1mm all the way along the Striking plate. A2029 sensor was fitted right on the edge of the 4mm range, and If john gently wobbled the sensor it went on and off. Now lowered

With the Front Air Fitting Being offset at the Nose seal end , it means The Air pipe from the Blue Triangle Cover and the air fitting need to be re positioned or a longer pipe fitted when placed on a Zx5

Check Clutch Plate Torque Loading- Still to follow. The Steel Plates fitted all together as C cup Plates is the setting for Maximum load required to Make the Torque Limiter Slip.