Check Clutch Plate Torque Loading- Still to follow. The Steel Plates fitted all together as C cup Plates is the setting for Maximum load required to Make the Torque Limiter Slip.
Z055 - ZX4 has been fitted using existing Software setup so Ou_InvDP not used (24v linked to S3 and S4.X308 - Inverter Zero fitted but not used. Uses Drive Run Fwd not using SMOT.
The sensor gap should also be checked after installation. The maximum Gap to operate is upto 4mm.
ideally the sensor should be setup to read closer than this - about 1mm all the way along the Striking plate.
A2029 sensor was fitted right on the edge of the 4mm range, and If john gently wobbled the sensor it went on and off.
Now lowered
With the Front Air Fitting Being offset at the Nose seal end , it means The Air pipe from the Blue Triangle Cover and the air fitting need to be re positioned or a longer pipe fitted when placed on a Zx5
Gareth Green
Jan 30 at 2:15 pm
×
Erreur de saisie dans le nom du tutoriel
Vous avez entré un nom de page invalide, avec un ou plusieurs caractères suivants :
< > @ ~ : * € £ ` + = / \ | [ ] { } ; ? #
Connexion
Pas encore enregistré ? Créez un compte pour profiter de toutes les fonctionnalités du service !
Alarms Need adding