Voir la source de Autocut Piece Jammed

{{Tuto Details
|Description=<translate>What to do if a small offcut is trapped int he machine leading to errors</translate>
|Categories=Operation
|Difficulty=Easy
|Duration=5
|Duration-type=minute(s)
|Tags=Autocut, offcut, trapped
}}
{{Introduction
|Introduction=<translate>Let's say a small piece has become wedged between the eject table and the outfeed table frame.

{{Warning|...Do not try to reach into the machine until it is safe to do so - Press ESTOP}}<br /></translate>
}}
{{Materials}}
{{EPI}}
{{Tuto Step
|Step_Title=<translate>Press any Emergency Stop button</translate>
|Step_Content=<translate>This will dump the air to the cylinders and probably free off the jammed piece</translate>
}}
{{Tuto Step
|Step_Title=<translate>Wait for the Saw Blade to stop</translate>
|Step_Content=<translate>{{Warning|...It is important to let the saw blade run down to standstill}}</translate>
}}
{{Tuto Step
|Step_Title=<translate>Remove the jammed piece</translate>
|Step_Content=<translate>You may need to pull the remaining bar left to cut out of the way</translate>
}}
{{Tuto Step
|Step_Title=<translate>Reset the Software</translate>
|Step_Content=<translate>Press [F10 Reset] on winSaw, this will reset all outputs. 

Now you can press the blue button on the console [ES RESET] - this will reset the emergency stop circuit and put air back on the machine.</translate>
}}
{{Tuto Step
|Step_Title=<translate>Check Bar Queue</translate>
|Step_Content=<translate>Look at the bar queue and check whether the last bar was marked cut [Y] or not cut [N].

If marked Cut then the jam most likely occurred on the last piece - if so, carry on.</translate>
}}
{{Tuto Step
|Step_Title=<translate>Recut the bar if necessary</translate>
|Step_Content=<translate>If not marked cut you have a couple of options; 

# if all pieces for the job have been finished mark the bar as cut and carry on. 
# If not all pieces have been cut you can either place a new bar on and using the bar queue editor, re-cut the whole bar or mark the bar as cut and finish the remaining pieces manually after the batch</translate>
}}
{{Notes}}
{{PageLang
|SourceLanguage=none
|IsTranslation=0
|Language=en
}}
{{Tuto Status
|Complete=Draft
}}