]> 2026-05-26T09:15:25+02:00 ZX5 Installation Procedure 0 en Draft Correct procedure for ZX5 Installation Very hard 5 day(s) use-protective-footwear use-protective-clothing use-protective-headgear use-reflective-vest for-maintenance-disconnect-from-mains <div class="icon-instructions caution-icon"> <div class="icon-instructions-icon"><i class="fa fa-exclamation-triangle"></i></div> <div class="icon-instructions-text">...Read the risk assessment and method statements before proceeding.</div> </div> false en none No hard pipe under the Saw. * Add air temporarily to the lift rollers to create datum in their up position. * Use laser to level and set height so that the M/C Outfeed rollers are parallel to M/C Rollers, but 0.5-1.0mm lower than the M/C Rollers. * Measure up diagonals to get the two transfer frames fully parallel. * Measure the gap between the frames, ensuring the male posts on the stub arms (on frames) are same distance as the hole centres on the transfer beams. * Level the frame. * Position Transfer Arms 1 and 9 to fine tune the frame positions. * Place a level on these two transfer arms. * Level the frame again using the two transfer arms to indicate if the Saw Infeed frame needs to be raised or lowered. * Recheck level and squareness of Saw Infeed. <br/> *Use the aluminium setting jig with the gripper holes. *Clamp the jig with the clamps (manually, as air is not switched on yet) *Move the frame and use the gripper as the guide to drop into the holes. *Use laser to align the frame in parallel with the backfence, taking care not to lose the gripper position relative to the gripper holes. <div class="icon-instructions caution-icon"> <div class="icon-instructions-icon"><i class="fa fa-exclamation-triangle"></i></div> <div class="icon-instructions-text">...DO NOT USE THE GRIPPER ADJUSTMENT TO MOVE THE GRIPPER IN RELATION TO THE HOLES.</div> </div> *With the outfeed beam in its fully extended position, and the gripper at the end of travel, there gripper should not be able to clash with the infeed top clamp. This should leave the end of the beam 75 +/-3mm from the MH Cross Bar<br/> Ensure the area is clear Position transfer tables in relation to floor plan Level machining centre outfeed frame Square up and level Saw infeed Position Extraction Unit Adjust height of Saw Infeed to be level with M/C Outfeed Position M/C and level up Position M/C Infeed and level up Position Sawing Module and level up Position Saw Outfeed and level up Fit Conveyor Mark floor area out roughly with marker pen Fit Transfer Gate (between MH and Saw) Fit Extraction Piping and Extraction Gates Fine positioning of Machining Centre Outfeed Position remaining transfer arms ZX5 Install 2025-08-19T09:05:39Z 2460906.8789236 ZX5 Installation Procedure 0 false false 0 0 0 1 plainlist 3 [[:Dokit:DocOptions]] [[DokitEPIEnable::yes]] ZX5 Installation Procedure# QUERYee7a61aae48f1c3f91d8e4d7736360be