]> 2026-05-26T18:45:57+02:00 ZX4 Infeed Roller Reinforcement 0 en Draft The design of the ZX4 Infeed Table was such that the first roller was located by a single block, of which was attached to the first arm by 2 bolts and a single dowel. The clearance on the two bolt holes meant that the block could rotate slightly around the dowel, resulting in the roller having a large potential deflection when load was put on it. Medium 2 hour(s) A plate has been designed to strengthen the installation of the first roller. false en ZX4_Infeed_Roller_Reinforcement_Annotation_2020-03-31_142909.jpg none Align the infeed roller block so that it is square (check the roller with a straight edge against the other rollers). Fit the bracket using the 2 off M8 x 25 Bolts. Mark through the clearance holes on the bracket onto the roller block. Reinstall strengthening bracket with 2x M8 x 16 Bolts (F0000023) into the infeed roller block, and the 2x M8 x 25 Bolts (F0000025) into the infeed arm. Remove the 2x M8 bolts as shown. Align Infeed roller block Remove the new strengthening bracket. Drill and tap into the infeed roller block Recheck alignment of infeed roller ZX4 Infeed Reinforcement 2020-03-31T13:34:14Z 2458940.0654398 ZX4 Infeed Roller Reinforcement 0 false false 0 0 0 1 plainlist 3 [[:Dokit:DocOptions]] [[DokitEPIEnable::yes]] ZX4 Infeed Roller Reinforcement# QUERYee7a61aae48f1c3f91d8e4d7736360be