]> 2026-05-26T09:16:01+02:00 Training Laser on Ecoline 0 en Draft The laser on an Ecoline needs to be specially set up to measure the profile accurately Medium 10 minute(s) The laser needs to be focused on the work area and not the receiver The smaller the dot for the profile to break/make the more accurate the laser false en Item-Laser_Focusing_Spanner_IMG_1269.jpg none Place a clean, white profile or sheet of paper in the clamps and adjust the Y axis position so the laser dot can be seen below it Focus the laser to make the dot as small as possible on the base of the profile Finally the laser receiver sensitivity needs to be checked. Unscrew the adjusting screw (AntiClockwise) until the GREEN Led goes RED. . Then turn screw (Clockwise) until RED Led goes back to GREEN then turn a further 5 full turns the same way, the receiver sensitivity is now set Remove the laser dust cover Focus Sensitivity Replace Dust cover Replace lower guard Remove the lower guard access plate ecoline laser accuracy focus 2025-08-01T09:46:07Z 2460888.9070255 Training Laser on Ecoline 0 false false 0 0 0 0 plainlist 1 [[:Item:Laser Focusing Spanner]] Training Laser on Ecoline# QUERYa1b13e5ac4a13d138c3410bc5870cf61 0 1 plainlist 3 [[:Dokit:DocOptions]] [[DokitEPIEnable::yes]] Training Laser on Ecoline# QUERYee7a61aae48f1c3f91d8e4d7736360be