]> 2026-05-26T12:09:56+02:00 Setting Profile Detection Laser Sensor 0 en Published Setting the laser sensor used on Flowline / ZX offcut sensors and Autoflow measurement sensors Medium 5 minute(s) Setting the profile sensor correctly is important as it will lead to incorrect offcut measurement. <div class="icon-instructions pin-icon"> <div class="icon-instructions-icon"><i class="fa fa-thumb-tack"></i></div> <div class="icon-instructions-text">...It is especially important to ensure the sensor is set for the range of different colours</div> </div><br/> false en Setting_Profile_Detection_Laser_Sensor_Annotation_2019-11-13_170514.jpg none <div class="icon-instructions caution-icon"> <div class="icon-instructions-icon"><i class="fa fa-exclamation-triangle"></i></div> <div class="icon-instructions-text">...Incorrect L/D setting will make the sensor read back to front</div> </div> # Turn L/D adjustment clockwise so it is on its maximum "L" # Turn anticlockwise until Yellow light comes on # Turn clockwise until Yellow light goes off Set range to 80-100mm using your hand or a piece of profile. # Place the object to sense at the "just off" position # Adjust sensitivity clockwise until Yellow light goes off # Check by moving the bar into "just on" position Set up Dark / Light setting Set the Sensitivity Vimeo 2019-11-13T17:21:20Z 2458801.2231482 Setting Profile Detection Laser Sensor 0 true true 0 0 0 1 plainlist 3 [[:Dokit:DocOptions]] [[DokitEPIEnable::yes]] Setting Profile Detection Laser Sensor# QUERYee7a61aae48f1c3f91d8e4d7736360be