]> 2026-05-26T09:17:52+02:00 R0015085 Mount SR Datum Sensor and Flag 0 en Draft Mounting details for SR axis flag and sensor Medium 0.25 hour(s) '''<u>Tools Required</u>''' Standard Hex key set Standard spanner set '''<u>Parts required</u>''' D0015489 Saw Turntable Sensor Bar x 1 E0000336 Sensor: M8; 2mm, PNP N/O, M8 conn x 1 M0001165 U bolt 3nb M12 BZP x 1 <br/> false en R0015085_Mount_SR_Datum_Sensor_and_Flag_Screenshot_2023-10-20_075214.png none All bolts to have Loctite 243 adhesive applied unless otherwise stated All Threaded Pneumatic connections to have Loctite 570 applied All bolts to be pen marked once adhesive applied and correct tension added Set sensor height to minimal clearance (-1mm ) Check gap is consistent on full travel over sensor flag when head is rotated Attach u bolt and sensor bracket on infeed mounting pillar Fix with M12 nuts and M12 A form washers Ensure bracket is mounted square to pillar base, only apply light tension to M12 nuts Set Height of U bolt bracket assembly in relation to flag on saw motor plate, to set sensor withing +- 2mm of flag Finalise M12 nuts and ensure U bolt assembly is mounted true as to not impact on side sheet guarding panel when fitted later Check sensor position has not moved once finalised, double check correct operation of sensor. Sensor should be within -1mm at all points of travel onto SR axis datum flag. Sensor should NEVER be in contact with flag at any point of movement '''Only fit one sensor lock nut and shakeproof washer to assembly as shown''' Fit E0000336 sensor to assembly Leave 10mm protrusion from top of bracket as shown Ensure shakeproof washer is fitted under sensor nut Unless otherwise stated Attach sensor bracket Fit sensor Set height Set sensor height Finalise Check sensor 2023-12-04T14:51:28Z 2460283.1190741 R0015085 Mount SR Datum Sensor and Flag 0 false false 0 0 0 1 plainlist 3 [[:Dokit:DocOptions]] [[DokitEPIEnable::yes]] R0015085 Mount SR Datum Sensor and Flag# QUERYee7a61aae48f1c3f91d8e4d7736360be