]> 2026-04-28T00:37:05+02:00 Programming Eaton DE Drive 0 en Draft Programming the Eaton DE Drive Easy 10 minute(s) false en ZX5_-_Specialised_Settings_for_Eaton_DE_Drives_Eaton-PowerXL-DE1-250.jpg none Set these references P-20 to P-23 to 50Hz so it will not matter what input 3 or 4 is set to - it will always be 50Hz Press the button in the top toolbar with a picture of the drive and a red arrow Click on the Extended tab Set the P15 Config Mode to 2, which means [Fwd][Rev][Freqbit1][FreqBit2] Programming lead is kept at Stuga Software can be downloaded at http://www.drive-support-studio.com/OTS/Eaton/downloads/deploy/drivesConnect.htm Select Parameter Edit from the menu Click on Scan Drive Network to find the drive you are plugged in to You may need to change the COM port to get this to work * Set Accel (1) and Decel (2) according to which crank you are programming. Details of which can be found [[ZX5 - Specialised Settings for Eaton DE Drives|here]] * Unlock Extended Parameters - Set P14 (3) to 101. This creates the "Extended" tab on the top Scan Network for Drive Set Config Mode Set Frequency References Plug programming lead and run DrivesConnect Software Set Parameters Transfer Current Data Set to Drive eaton de1 crank programming 2020-10-06T08:40:44Z 2459128.8616204 Programming Eaton DE Drive 0 false false 0 0 0 1 plainlist 3 [[:Dokit:DocOptions]] [[DokitEPIEnable::yes]] Programming Eaton DE Drive# QUERYee7a61aae48f1c3f91d8e4d7736360be