]> 2026-05-26T16:59:54+02:00 Flowline Turret Upgrade - Somatec 0 en Draft Flowline Turret Upgrade Easy 120 minute(s) false en none Remove all parts from the existing turret, to leave just the mounting plate and the cylinder and fittings etc, as shown Fit the Somatec mount block (D0015715) with M8 bolts (you will need to remove the mounting plate from the hood to bolt in from behind. Fit Somatec turret with 3 off M6 bolts. <br/> Fit new strike plate. It has the same mounting points etc as existing one, so all fittings can be reused Install bolts into the turret head, according to required length. Ensure that they strike on the strike plate. <nowiki>The feedback should count up in binary for the position selected<br /><br/><div class="mw-highlight mw-content-ltr" dir="ltr"><pre>Pos IxA IxB IxC<br /> 1 1 0 0<br /> 2 0 1 0<br /> 3 1 1 0<br /> 4 0 0 1<br /> 5 1 0 1<br /> 6 0 1 1</pre></div><br/></nowiki> Using the IO screen, rotate to position 1. #Using a pneumatic pipe marker, Label the "active" bolt with the number relating to the feedback position #Using a permanent marker, label the capstan where it is clearly visible Repeat for all 6 positions Remove existing turret and associated parts Fit Sometec mount Fit Somatec turret Fit the new strike plate Fit new bolts into rotating head of turret Test rotation and feedback from IO screen Label the turret bolts and capstan positions 2020-09-29T13:25:36Z 2459122.0594444 Flowline Turret Upgrade - Somatec 0 false false 0 0 0 1 plainlist 3 [[:Dokit:DocOptions]] [[DokitEPIEnable::yes]] Flowline Turret Upgrade - Somatec# QUERYee7a61aae48f1c3f91d8e4d7736360be