]> 2026-06-13T21:15:18+02:00 Changing saw pusher bearings - Standalone Saw 0 en Draft Instructions on how to change Saw pusher bearings on a standalone saw infeed. Medium 30 minute(s) false en none Bring the Saw pusher to the end where the chain tensioner and sprocket are. Remove the pusher arm by taking out 2 bolts below the arm. Remove the face plate by taking out the 4 bolts in the fron of the plate Take off the top roller bearings. loosen off the 8 bolts on the back of the tension assembly to release the tension. Take out the 4 bolts holding plate with sprocket on. Make sure the chain comes away from the sprocket teeth. Slide this plate out. <br/> Remove the bolts from the stop block holding it to the shaft. Slide the pusher assembl;y off the shaft Clip the Yellow innner piece of the bearing out of the new Bearings recevied. Do the same on the bearings currently fitted. Replace the old with the new inner piece, making sure they are clipped in correctly. slide the pusher assembly back on. Re-fit stop block using the bolt which was removed. Remove Face plate & pusher arm on Saw pusher Slacken tension off the chain Remove back plate of tension assembly Take off stop block Remove pusher assembly off Changing Bearing inner piece Re-fit pusher assembly and Stop block Saw pusher linear bearing replace bearings infeed standalone saw 2019-09-26T11:07:40Z 2458752.9636574 Changing saw pusher bearings - Standalone Saw 0 false false 0 0 0 1 plainlist 3 [[:Dokit:DocOptions]] [[DokitEPIEnable::yes]] Changing saw pusher bearings - Standalone Saw# QUERYee7a61aae48f1c3f91d8e4d7736360be