]> 2026-05-26T19:47:22+02:00 Autoflow Maintenance - Sawing Centre 0 en Draft Procedures for Daily, Weekly and Monthly Maintenance on Autoflow Sawing Centre Module Medium 2 hour(s) The Machine has many moving parts, all which need regular maintenance. Below outlines what items need particular attention false en Autoflow.jpg.jpg none * Remove any debris from clamp pads and rollers * Visually check the rollers and clamp pads for damage or excessive wear, oil rollers with supplied oil, visually check cylinder rods for damage Using the supplied straight-edge, check the backfence alignment through machine. Misalignment is the normat cause of inaccuracy issues Use a suitable foam cleaner for cleaning off the glue and tape residue left by the profile rolling along the beds Check saw blade teeth for wear or damage, check saw blade for warping <div class="icon-instructions caution-icon"> <div class="icon-instructions-icon"><i class="fa fa-exclamation-triangle"></i></div> <div class="icon-instructions-text">...When changing blade – ensure that the correct type and size saw blade is used, using the wrong type / size of blade can cause accuracy issues – Please refer to your Stuga manual for the correct specification of blade or contact Stuga Service for further assistance</div> </div><br/> * Check that the drive belt is free from wear or any cuts / nicks along the circumference of the belt * Ensure that the drive belt has sufficient tension via the tension roller * Check the leadscrew for any wear or damage * Grease with 1 Pump if lubricator not fitted <div class="icon-instructions info-icon"> <div class="icon-instructions-icon"><i class="fa fa-info-circle"></i></div> <div class="icon-instructions-text">...Only used if compound VS cut machine option</div> </div> * Check rollers and runner surface for damage or wear * Lightly oil rollers and runner surface * Visually check pinion wheel and slewing ring for any damage, chips or cracks * Remove any debris that may have become caught up in the teeth * Turn assembly through full range of movement to check for any tight spots * Grease ring on grease points. 1 Pump each * Lightly oil rail surface with supplied oil * Ensure reference sensor is not damaged <div class="icon-instructions info-icon"> <div class="icon-instructions-icon"><i class="fa fa-info-circle"></i></div> <div class="icon-instructions-text">...There are 4 rails in total, 2 at front and 2 at rear</div> </div><br/> Ensure that the Hose and Chute are not blocked by large offcuts <div class="icon-instructions caution-icon"> <div class="icon-instructions-icon"><i class="fa fa-exclamation-triangle"></i></div> <div class="icon-instructions-text">...Side open the Extraction separator base to empty offcuts</div> </div> Check Hose for damage / cuts – replace if necessary Horizontal and Vertical clamps Stainless Steel Bed Saw Blade Area Saw Tilt Rollers SR Axis Slewing Ring and Pinion SY Axis Linear Rails Extraction Separator Check Rear Fence Alignment SZ Axis Saw Up / Down Drive Autoflow Maintenance Sawing 2022-12-08T16:03:12Z 2459922.1688889 Autoflow Maintenance - Sawing Centre 0 false false 0 0 0 1 plainlist 3 [[:Dokit:DocOptions]] [[DokitEPIEnable::yes]] Autoflow Maintenance - Sawing Centre# QUERYee7a61aae48f1c3f91d8e4d7736360be