]> 2026-05-26T05:08:32+02:00 Autoflow Maintenance - Infeed 0 en Draft Weekly and Monthly Maintenance Procedures for Autoflow Infeed Table Easy 30 minute(s) <nowiki>The following preventative maintenance tasks should be carried out regularly on the machine. The frequency depends on the machine use, but as a guide:<br /><br/><div class="mw-highlight mw-content-ltr" dir="ltr"><pre>2-3 Shifts Weekly<br />40 Hrs/Week Bi-Weekly<br />20 Hrs/Week Monthly</pre></div><br/></nowiki> false en Autoflow.jpg.jpg none Use a suitable foam cleaner for cleaning off the glue and tape residue left by the profile rolling along the beds Clean display with soft cloth to avoid dirt, etc. causing malfunction of the touch screen Apply oil to top and side of roller units and then slowly spin them for a few revolutions to allow the oil to penetrate the bearings 1 pumpsof grease via grease nipple, check for any signs of damage or wear Check function and operaton of each paddle - ensure it does not stick in up or down position Ensure the end stop slides on the linear cylinder. The system acts under a low constant pressure and should slide easily Using the Service screen, check the pop up rows rise and sink in unison Stainless Steel Bed Main display unit (Monitor) Drive shafts Rear Backfence Rollers Flapper Paddles End Stop Pop-Up function Autoflow Maintenance Weekly Monthly 2022-12-06T17:00:26Z 2459920.2086343 Autoflow Maintenance - Infeed 0 false false 0 0 0 1 plainlist 3 [[:Dokit:DocOptions]] [[DokitEPIEnable::yes]] Autoflow Maintenance - Infeed# QUERYee7a61aae48f1c3f91d8e4d7736360be