]> 2026-05-26T09:15:50+02:00 Autocut Piece Jammed 0 en Draft What to do if a small offcut is trapped int he machine leading to errors Easy 5 minute(s) Let's say a small piece has become wedged between the eject table and the outfeed table frame. <div class="icon-instructions caution-icon"> <div class="icon-instructions-icon"><i class="fa fa-exclamation-triangle"></i></div> <div class="icon-instructions-text">...Do not try to reach into the machine until it is safe to do so - Press ESTOP</div> </div><br/> false en none This will dump the air to the cylinders and probably free off the jammed piece <div class="icon-instructions caution-icon"> <div class="icon-instructions-icon"><i class="fa fa-exclamation-triangle"></i></div> <div class="icon-instructions-text">...It is important to let the saw blade run down to standstill</div> </div> You may need to pull the remaining bar left to cut out of the way Press [F10 Reset] on winSaw, this will reset all outputs. Now you can press the blue button on the console [ES RESET] - this will reset the emergency stop circuit and put air back on the machine. Look at the bar queue and check whether the last bar was marked cut [Y] or not cut [N]. If marked Cut then the jam most likely occurred on the last piece - if so, carry on. If not marked cut you have a couple of options; # if all pieces for the job have been finished mark the bar as cut and carry on. # If not all pieces have been cut you can either place a new bar on and using the bar queue editor, re-cut the whole bar or mark the bar as cut and finish the remaining pieces manually after the batch Press any Emergency Stop button Wait for the Saw Blade to stop Remove the jammed piece Reset the Software Check Bar Queue Recut the bar if necessary Autocut offcut trapped 2019-10-10T16:47:31Z 2458767.1996644 Autocut Piece Jammed 0 false false 0 0 0 1 plainlist 3 [[:Dokit:DocOptions]] [[DokitEPIEnable::yes]] Autocut Piece Jammed# QUERYee7a61aae48f1c3f91d8e4d7736360be