Voir la source de Changing saw pusher bearings - Standalone Saw

{{Tuto Details
|Description=<translate>Instructions on how to change Saw pusher bearings on a standalone saw infeed.</translate>
|Categories=Maintenance
|Difficulty=Medium
|Duration=30
|Duration-type=minute(s)
|Tags=Saw, pusher, linear bearing, replace bearings, infeed, standalone saw
}}
{{Introduction
|Introduction=<translate></translate>
}}
{{Materials}}
{{EPI}}
{{Tuto Step
|Step_Title=<translate>Remove Face plate & pusher arm on Saw pusher</translate>
|Step_Content=<translate>Bring the Saw pusher to the end where the chain tensioner and sprocket are. Remove the pusher arm  by taking out 2 bolts below the arm.

Remove the face plate by taking out the 4 bolts in the fron of the plate 

Take off the top roller bearings.</translate>
}}
{{Tuto Step
|Step_Title=<translate>Slacken tension off the chain</translate>
|Step_Content=<translate>loosen off the 8 bolts on the back of the tension assembly to release the tension.</translate>
}}
{{Tuto Step
|Step_Title=<translate>Remove back plate of tension assembly</translate>
|Step_Content=<translate>Take out the 4 bolts holding plate with sprocket on.

Make sure the chain comes away from the sprocket teeth.

Slide this plate out.

<br /></translate>
}}
{{Tuto Step
|Step_Title=<translate>Take off stop block</translate>
|Step_Content=<translate>Remove the bolts from the stop block holding it to the shaft.</translate>
}}
{{Tuto Step
|Step_Title=<translate>Remove pusher assembly off</translate>
|Step_Content=<translate>Slide the pusher assembl;y off the shaft</translate>
}}
{{Tuto Step
|Step_Title=<translate>Changing Bearing inner piece</translate>
|Step_Content=<translate>Clip the Yellow innner piece of the bearing out of the new Bearings recevied. 

Do the same on the bearings currently fitted.

Replace the old with the new inner piece, making sure they are clipped in correctly.</translate>
}}
{{Tuto Step
|Step_Title=<translate>Re-fit pusher assembly and Stop block</translate>
|Step_Content=<translate>slide the pusher assembly back on. 

Re-fit stop block using the bolt which was removed.</translate>
}}
{{Tuto Step
|Step_Title=<translate></translate>
|Step_Content=<translate></translate>
}}
{{Notes}}
{{PageLang
|Language=en
|SourceLanguage=none
|IsTranslation=0
}}
{{Tuto Status
|Complete=Draft
}}